PCB Molex Board Design

I need a small, passive breakout PCB designed in EasyEDA and built at JLCPCB. One edge of the board carries a board-mount Molex Mini-Fit Plus PCB receptacle (4.20 mm, dual-row, 4-circuit), and the opposite edge carries a 4-position screw terminal block. The two connectors are wired 1:1 — each Mini-Fit circuit goes straight to one screw terminal. There are no active components; this is purely a connector-to-connector pass-through for power/signal and this will be treated as an inline adapter. Connectors (fixed) Input (front edge): Molex 46010-0411 — Mini-Fit Plus PCB Receptacle, 4.20 mm pitch, dual row, vertical, blind-mating, 4-circuit, through-hole, snap-in plastic peg PCB lock. Output (back edge): 4-position screw terminal block, pitch chosen to match the per-circuit current above (a 5.0 / 5.08 mm pitch block rated ≥ the load is the likely default). Prefer a part that is stocked in the JLCPCB/LCSC library or even pcbway. Deliverables: Editable EasyEDA project (schematic + PCB layout). Gerber files, JLCPCB-ready. BOM and CPL/pick-and-place in JLCPCB format, with LCSC part numbers where parts are library stock. 3D render and/or STEP of the assembled board.